The B&W D3 plate adaptor replaces the wheels on B&W D3 speakers and provides a threaded hole for the appropriate GAIA stud to screw into.

Fog Lifters significantly reduce RF coupling, whether with the floor, or due to misdirected efforts to isolate cable with stands or clamps that themselves have too much mass and are sources of RF Noise. A few inches or centimeters might not seem important, but as with light coming from a bulb, the energy falls off exponentially. A few inches or centimeters makes a big difference—which translates into a lower noise-floor and less compromise to, and distortion in, attached active circuits.

Nordost’s DC cable uses 2 x 22 AWG, silver-plated, solid-core OFC conductors, which have been arranged in a twisted pair construction. This geometry helps to eliminate noise within the cable. However, to further safeguard from RFI and EMI, the conductors are protected by a braided shield. Additionally, the QSOURCE DC Cable uses Nordost’s Micro Mono-Filament technology in order to increase signal speeds by introducing an air-dielectric to the cable design.

The DELOS butcher block from IsoAcoustics decouples the turntable from the supporting surface and dramatically diminishes structural vibrations and resonances, resulting in greater clarity and detail.

This series of isolation feet by Tungsten Grooves was created to efficiently absorb vibrations from your audio equipment, relying on the absorptive properties of tungsten to unlock hidden details in your music system. The W70-H47, affectionately known as the Fat Boy, is the largest foot in the series offering the greatest performance.

If one of your audio components suffers from an irritating transformer hum, then the DC Blocker is the perfect product for you. By intelligently blocking DC voltage greater than 1,000mV (the main cause of humming), the DC Blocker can eliminate the transformer hum in your equipment. The DC Blocker manages this while maintaining equipment safety and EMI shielding to ensure there are no negative side effects. Additionally, the DC Blocker can be used anywhere around the world!

If you can hear a consistent hum coming through your speakers, whether playing music or when idle, then you may have multiple ground/earth connections in your system causing a ground loop. This ground loop can be fiddly to fix, however, iFi have come along with an intelligent solution to help solve this issue. Enter the GND Defender! By using a specially designed AI Ground Detection, the GND Defender can automatically disconnect the ground on your device if there is a ground loop, eliminating the low hum through your speakers. But it does not stop there, the GND Defender can even reinstate the ground connection to pass current if any faults are detected in your system. This ensures a safety fallback to help protect your equipment.